Carbon Reproductions 2013-2020 Subaru BRZ / FRS / GT86 OE-Style Carbon Fiber Rear Spoiler

2017+ OEM STYLE CARBON FIBER SPOILER

Toyota and Subaru recently debuted facelifted models. The premium versions (TRD / Limited) featured a new OEM spoiler with black center portion and paint matched ends. This Carbon Reproductions model wraps a gloss carbon fiber layer over every surface in view.

Carbon fiber body parts attract a lot of attention and rightfully so. These parts require no additional sanding or painting to mount. You receive the finished product which has a high gloss finish and are able to install it immediately. The end result is an extremely premium look.

OE-Style Carbon Fiber Rear Spoiler is sporty and sleek.

This is a quick, affordable way to add some carbon fiber to your vehicle.

If a dramatic appearance upgrade is what you’re looking for, look no further.

OE design meets beautiful carbon fiber. Includes pre-mounted 3M and bolts.

DETAILS:

• Fiberglass construction with a carbon fiber layer on top
• Glossy carbon fiber finish
• Pre-drilled provisions to make for a direct bolt-on installation
• Includes all new hardware

INSTALLATION INSTRUCTIONS

These premium spoilers attach with a combination of 3M tape and 4 bolts.

STEP 1

Tape off the corners of your rear decklid with painter’s tape. You must tape a large enough portion to trace the pedestal.

Center the spoiler on the trunk. Make sure the gaps between the pedestal and the outer edge of the trunk are even on both sides. There are two curves on the back side of the trunk. Make sure that the trail edge of the pedestal aligns with the TOP curve and not the bottom curve.

STEP 2

Start on one side and trace around the pedestal enough so that you can position the 3M plastic backing seen in step 3. Upper mark, lower mark, and marks on both sides should be enough. Repeat for the other side.

Remove the 3M backing plastic from each pedestal, noting which side they came from. Store the spoiler in a safe area for this short time so that it does not become damaged nor does anything get on the bottom of the 3M tape.

STEP 3

Align the plastic backing with the text facing downwards so you can locate the area where the bolt is inserted. Place a circle in the middle of the square as a guide for drilling.

STEP 4

Use the templates you just made to drill a pilot hole through both the top of the trunk. Then use a drill bit similar in size to the bolt to go through the top of the trunk and the bottom layer. Once you have done this, you will need to use a hole saw bit to enlarge the hole on the inside of the trunk. This is the only way you can tighten the bolt. It has to be wide enough to insert a socket.

Verify that all bolts can pass through the holes and all bottom holes are wide enough Once you have done this for all 4 holes (2 per side), you can remove the painter’s tape and remove the remaining 3M plastic backing off the spoiler (center).

STEP 5

Bolt the wing to the vehicle. You can use silicon gasket maker around the holes as a precautionary step to prevent moisture intrusion.

---

Let’s Connect!

At BCB Performance, we are real car enthusiasts who take “customer service” very seriously. We understand that finding the right parts can be overwhelming, we are here to help. The JDM Specialists at BCB Performance are here to give you the best buying experience while providing education and insight on any products and questions you have. These are the fundamentals that differentiate us from others. If you are unsure of the stock status, ETA, fitment, ship time, etc. of an item, please contact us! Let us make this experience simple, easy, and awesome for you – So without hesitation give us a call at (317) 207-2128, direct message us on our live chat or CLICK HERE to contact us via email.

Make sure to follow us on Instagram: @bcbperfomance

EMAIL A JDM SPECIALIST FOR HELP CALL A JDM SPECIALIST NOW

Brand